Owner`s manual

Manual Part No: 930004-01 MD Gas Range - 20 –
Manual Rev No: 1
Users Instructions (cont.)
Lighting Instructions:
Open Hotplates
1) To turn on an individual open top hotplate burner, push in the appropriate gas tap knob and
turn it anti-clockwise to the double flame position, the “Full ON” position. At the same time apply
a lighted taper to light the burner head.
2) Keep knob depressed for a further 20 seconds until flame is established.
3) If flame is extinguished on releasing knob, wait 3 minutes then repeat steps 1 & 2.
4) To turn down or lower the heat, turn the gas tap knob anti-clockwise from the “Full On” position
until the desired flame height is reached. Turned fully anti-clockwise to the single flame
position, is the lowest setting.
Note! When first lighting the appliance or after installation or after an extended shut-down period, it
may be necessary for gas control knob to remain pushed in for some time before burner will light, owing
to the presence of air in gas line.
To Turn Off:
Turn the gas tap knob fully clockwise (beyond the “Full On” position) to the “Off” position λ.
Drip Tray:
A drip tray is fitted beneath the burners to catch any spillage. During normal use this drip tray and
handle get hot. Only remove the tray after it has cooled or with suitable gloves.
Solid Hotplates
1) Lift out the central portion of the solid top (using lifting tool) and place to one side. This exposes
the in-line burner (K) and the flame failure thermocouple (N).
2) Push in the gas tap knob (C) and turn it anti-clockwise to the double flame position, the “Full
ON” position. At the same time apply a lighted taper to light the burner head.
3) Keep knob depressed for a further 20 seconds until flame is established.
4) If flame is extinguished on releasing knob, wait 3 minutes then repeat steps 1 & 2.
5) Replace the removable solid hotplate section.
6) Check that the burner has ignited by observing through the two viewing holes (A).
7) To turn down or lower the heat, turn the gas tap knob anti-clockwise from the “Full On” position
until the desired flame height is reached. Turned fully anti-clockwise to the single flame
position, is the lowest setting.