Owner`s manual

Page 9
For HELP, call 727.573.9611
Electrical Specifications
Important – Qualified and licensed electricians must perform all electrical
hookups. The following specifications must be followed in order to ensure proper
performance and safety.
WARNING: Starting an incorrectly wired hot tub could cause severe damage
to the mechanical equipment or even bodily harm. Have your
licensed electrician verify GFCI (or RCD) wiring with the
diagrams on pages 10-18 prior to starting the hot tub or call the
technical support line at 727.573.9611.
Caution: Failure to abide by specifications listed may result in damage to the
equipment and will void the warranty.
All hot tubs must be wired with the appropriately sized wiring. Failure to do so will
cause equipment damage and will not be covered under your warranty.
All hot tubs must be over current protected with a built-in GFCI (or RCD for
export models) in the service panel.
Model
Volts
(V)
Freq.
(Hz)
Rating
(A)
GFCI
(A)
Wire size from GFCI
to Main Panel
*†
Equipment_ Pack
1301, 1302 240 60 50 60
6-3 plus ground (up to 130’)
4-3 plus ground (up to 230’)
2-3 plus ground (up to 360’)
VS510SZ
Table 2 – Domestic Wire Size Chart
Model
Volts
(V)
Rating
(A)
RCD
(A)
Wire size from RCD
to Main Panel
‡
Equipment
Pack
1301,1302
220-
240
1x32
2x16
IEE Wire
Regulation
3x4 mm
2
5x1.5 mm
2
GS510SZ
Table 3 – Export Wire Size Chart
WARNING: Disconnect electrical power before servicing. Before
obtaining access to terminals, all supply circuits must be disconnected.
WARNING: Test the GFCI (or RCD) before each use.
Our hot tubs are certified by Intertek Testing, SNAa Ltd.
Ontario, Canada to CSA-C22.2 No. 218.1-M89 and ANSI/UL
1563 standards.
*
Wire size may need to be reduced at GFCI to fit into the breaker
†
Solid copper
‡
Solid copper