Owner`s manual

MOON i 3.3 Integrated Amplifier
Remote Control Operation
The MOON i 3.3 Integrated Amplifier uses the ‘CRM’ full-function remote control
(figure 3). It operates on the Philips RC-5 communication protocol and is can be
used with other Simaudio MOON components.
The ‘CRM’ remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the CRM remote for use with the MOON i
3.3 Integrated Amplifier, you
must first press the button labeled AMP.
The POWER button located on the upper left will switch the integrated amplifier to
either ‘Standby’ or ‘On’ mode.
The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all available inputs. For example, to switch from
the “A3” to the “CD” input, press ◄ INPUT three (3) times. To switch from
the “CD” to the “A3” input, press INPUT ► three (3) times. Pressing and
holding down either of these buttons results in only a single change to
the selected input.
The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level. Pressing ▼
VOL results in a decrease in the volume level; Pressing VOL ▲ results in an
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
Figure 5: CRM Remote Control
____________________________________________________________________________________
Remote Control Operation 14