User`s manual

Page 46
Voyager OS User’s Manual - Appendices
Page 47
Voyager OS User’s Manual - Appendices
Like the square wave, the triangle wave only contains odd harmonics,
but the levels of the harmonics in a triangle wave are much less. The
triangle wave has a soft, slightly buzzy sound that is suitable for high-
pitched leads (like a  ute) or adding a beefy sub-bass to bass sounds.
The sine wave is the purest waveform of them all. It has no harmonics,
so it produces a very pure tone. Because of this, sine waves generally
aren’t used as primary audio signals, but are often used to reinforce or
enhance other waves. They are also used as modulation sources.
Synthesizers often have more than one oscillator, and each oscillator usually has its own dedicated frequency,
waveform and level (volume) parameters. Several oscillators make possible rich and complex sound source
con gurations. Some synthesizers also permit external audio signals to serve as sound sources, allowing you
to combine them with the oscillators, or process the external audio by itself using the synthesizer compo-
nents.
The combined sound sources are routed to the Filter, a circuit that removes or reduces frequencies (and
in some cases, emphasizes them). Although there are several  lter types designed to remove high, low and
middle frequencies, most synths offer at least one type, and most often it’s a Lowpass  lter.
A Lowpass  lter gets its name because it allows low frequencies to pass
through while removing or reducing the high frequencies. The point
at which the  lter works to remove high frequency signals is called the
Cutoff. Above the cutoff, frequencies are gradually reduced according
to the  lter’s ‘slope’, which is a measure of how well the  lter works.
The slope of a  lter is expressed in decibels per octave (dB/Oct). The
Voyager  lter is rated at 24 dB/Oct, which creates a dramatic reduction
in unwanted frequencies. This is a highly desirable quality for subtractive
synthesis.
Another important  lter parameter is the  lter resonance. Resonance ampli es the frequencies at the
cutoff frequency, emphasizing any signal frequencies that appear there. It’s possible to adjust the resonance
control to the point where the  lter actually oscillates. When this occurs, the oscillation frequency is the
same as the cutoff frequency.
The Filtered signal is routed to the Ampli er, which controls the gain (volume) of the signal. The Ampli-
 er controls the dynamics of a sound, turning it on and off as you play. The Ampli er is usually paired with
an Envelope Generator (described below). The gain of the ampli er follows the contours of the Envelope
Generator signal, shaping the sound from start to  nish.
The Oscillator, Filter and Ampli er are voltage controlled, meaning that they respond to changes in voltages.
For the Oscillator, it means the higher the voltage, the higher the pitch. For the Filter, it means the higher the
voltage, the higher the cutoff frequency. For the Ampli er, this means the higher the voltage, the greater the
volume. Since each of the three main components respond to a voltage, the entire synthesis system thus
has a common control element. This provides great  exibility for sound programming, and allows auxiliary
components, like Envelope Generators and Low Frequency Oscillators (which generate control voltages) to
further vary the sound.