User`s manual

Page 28
Voyager OS User’s Manual - The Components
Page 29
Voyager OS User’s Manual - The Components
LFO/Sample and Hold Section Controls
Rate:
The
RATE
control sets the frequency of the LFO. The
RATE
control frequency range is approximately 0.2
to 50 Hz.
Wave:
The
WAVE
control selects the LFO waveform. There are four waveforms available:
-
Triangle
-
Square
-
Stepped Sample & Hold
-
Smooth Sample & Hold
Additional CV Connections
:
LFO Rate:
The
LFO RATE
jack accepts an expression pedal or a control voltage from -5 to +5V. A positive voltage
applied here adds to the position of the LFO
RATE
control, while a negative voltage will subtract from the
position of the LFO
RATE
control.
NOTE:
The S&H GATE jack will only work with a +5V Gate input, not a footswitch.
LFO Sync:
The
LFO SYNC
jack accepts a footswitch or a +5V Gate input. Closing the footswitch or applying a gate
signal here will retrigger the LFO waveform.
S&H In (Sample and Hold Input):
The
S&H IN
jack accepts an expression pedal or a control voltage from -5 to +5V. The voltage on this jack
is the signal source for the Sample and Hold circuit input.
S&H Gate (Sample and Hold Gate):
The
S&H GATE
jack accepts a +5V Gate input. Applying a gate signal here will trigger the Sample and Hold
circuit.
PERFORMANCE TIP:
By applying an external voltage to the LFO RATE jack you can
control the LFO frequency well beyond the speci ed range. Rates lower than one cycle
per minute are possible, as are frequencies that go well into the audio range.