User guide

Minimoog Voyager Editor Librarian Page 7
4 GETTING CONNECTED - MIDI SETUP
In order for the Editor/Librarian program to be fully functional with the Voyager hardware, the software must be
registered (not in Demo Mode) and the Voyager must be connected to the MIDI In and MIDI Out connections of
your computer's MIDI interface.
After making the proper connections between the Voyager and the MIDI interface, launch the Editor/Librarian. In
the program’s MIDI menu, select MIDI Setup. You’ll see the following window (your window may show different
MIDI IN Port and MIDI OUT Port information):
You will need to select the MIDI interface where your Voyager or RME is connected. Choose the correct MIDI In
and MIDI Out ports from the list, and set the MIDI channel to match the MIDI channel on your Voyager. Adjust the
Piano Note Velocity slider control if desired (this sets the MIDI Note Velocity value that the program will use to
audition presets. The default setting is 100, but you can adjust it from 0-127).
On the Voyager, make sure that MIDI In and MIDI Out is turned ON, SysEx is ENABLED, and MIDI Program
Change is turned ON (“Select Presets”).
Note: You may also need to make additional configurations using Apple’s Audio MIDI Setup Utility.
For more information, see Appendix A – OSX Audio MIDI Setup Procedure.