User guide
Minimoog Voyager Editor Librarian Page 19
Select the desired parameter from the Parameter pull-down menu and use the slider control to set the value.
The Parameter menu contains more than one hundred different parameters to choose from, including all 24
characters in the preset name:
After choosing the desired parameter and value, click on Change to apply the change, OK to quit and close the
drawer, or Cancel to cancel the function without changes. You can repeat this process multiple times by selecting
a new parameter and value, then clicking the Change button. This is especially handy for making several ‘global’
changes to groups of presets. Click OK when done.
Note: You must select Change in order for the change to be applied. Simply clicking OK after selecting a
parameter and value will not apply the change to the selected preset(s).
When a change is made using the Single Parameter Adjustment feature, the change is only applied to the
selected presets in the Editor User Bank – they are not automatically written to the Voyager. For this reason, you
should transfer your modified bank to the Voyager after making any parameter changes, or the changes may be
lost.
Note: Numerical values in the Single Parameter Adjustment drawer are displayed as 8-bit values (0-255)
when the Editor’s Parameter Resolution is set to 8-bit resolution. Values are displayed as 16-bit values
(0-65535) when the Editor Parameter Resolution is set to 16-bit resolution.