Operating instructions

Wireless Conguration
3.4
Note that the unit is set to a Wireless Mode
of Access Point and the default SSID for the
wireless network is set to videolarm.
Click on the Wireless tab on the conguration page.
Changing Wireless Mode
3.5
Place a check mark in the Auto box beside
the selection.
Connect to the second device and complete
the proceeding steps.
In most cases the units will connect to one
another using the Auto mode. However this
might not always be the case.
If the units do not connect automatically then
the MAC addresses for the devices will need
to be entered into the WDS Peers section.
The MAC address of the unit on the OPPOSITE
end of the connection must be entered in the
WDS Peers box.
Change the Wireless Mode to Access Point WDS.