Operating instructions
Wireless Security Options
3.2
Select the Encryption method that is desired
and enter the appropriate encryption key. Note
that this same key will need to be entered in
all devices connecting to the wireless network.
Click the Change button in the bottom right
hand corner to apply the security settings.
Encryption for the wireless link is also set from this page.
Complete the following steps to connect two VLRM58 units on the same wireless network using WDS.
VLRM24/58
3.3
• Connect to the VLRM24/58 by opening a web browser and connecting to http://192.168.1.1.
Login to the device using videolarm for the
username and camera for the password.
Click on the Network tab on the
conguration page.
Note that a static IP address of 192.168.1.1
has been assigned to the unit be default.
The default IP address, subnet mask, and
gateway can all be changed from this screen
if needed.
Click in the corresponding box and enter in
the required IP setting, then click the Change
button in the bottom right hand corner of
the window.
NOTE - Connection to the VLRM24/58 will be lost if the IP address is changed at this time. A connection will need
to be made to the new IP address that has just been assigned in order to view the conguration page again.