User`s manual

CALIBRATION INSTRUCTIONS
Overview
The SMK takes advantage of the sequence transpose function to
implement MIDI pitch bend. The two resistor and the 10K variable
resistor (potentiometer or pot) are used to control the MIDI
pitchbend range. The resistor located closest to the pot is used to
scale the maximum amount of pitch bend. The pot is used to fine
tune this adjustment. The other resistor (332K from Moog, or 665K
from Encore), is used to bring the rear panel tune control into
range. After the installation, the Source may require oscillator
scale adjustments. This is well documented in the Source
technical service information that was supplied with the
instrument. As a convenience, we have included it in this manual.
Symptom
The source may be in tune at one end of its range, but as it
reaches the other end, the tuning drifts.
Procedure
First set the control panel to the following:
Glide 0
Mod Off
Osc 1 32'
Waveshape Sawtooth
Sync Off
Osc 1 Mixer 99
Noise 0
Osc 2 Mixer 0
Filter Cutoff 0
Emphasis 0
Contour Amount 99
Both Sustains 99
All other contour functions 0
Octave transpose 0
Center the pitch wheel
Center the rear panel tune control