User Guide

36
- Move the cursor under the Setup Name, which
should be blank. Use the Value control to select
the first Character – “B” – then move the cursor to
the next character and select a “a”. Repeat this
until you have spelled “Bass and Vibe Space”.
- Press Escape to return to the Edit Menu.
Step 3 – Building the Layers
- First we’ll configure Channel 1. Move the cursor
under Chn Setup and press Enter.
- Move the cursor underneath the name of the
sound. Use the Value control to scroll through the
names, until you reach “Vibraphone”.
- Move the cursor underneath “Zone” and press
Enter. The display now prompts you to “Play Zone
boundaries”, which means the highest and lowest
note of the Zone. The boundary notes must be
played at the same time. Let’s set this Zone to
extend from the D flat below middle C to the
highest note on the piano. Play these two notes
simultaneously and then press Escape.
- Move the cursor back to “Midi: int” and press
Enter – page 2 of Channel Setup will now be
displayed.
- Move the cursor under the “Pan” setting, and use
the Value control to increase the pan to R6.
- Move the cursor under Reverb amount and set it
to 7. Press Enter to return to Page 1.
- Move the cursor under the Channel. Use the
Value control to increase the Channel number to
Channel 2.
- Now we’ll set up Channel 2. Move the cursor
underneath the name of the sound. Use the Value
control to scroll through the sounds until you reach
“Acoustic Bass”.
- Move the cursor underneath “Zone” and press
Enter. Play the C 1 octave below middle C and the
lowest A simultaneously to set the Zone
boundaries. Press Escape.
- Move the cursor back to “Midi: int” and press
Enter – page 2 of Channel Setup will now be
displayed.