User Guide

18
THE REAR PANEL CONNECTIONS
The Rear Panel contains all the connections to
hook the PianoBar up to the outside world.
• Power: The PianoBar requires a +12VDC center
positive power supply which can deliver 830
mA or greater. A power supply is provided with
the PianoBar.
• Pedal Controllers 1-3: These three ¼” TRS
(Tip/Ring/Sleeve) jacks accept an expression
pedal input. Works with moogerfooger EP-1 or
equivalent. All three pedal inputs can be
configured to send MIDI CCs in a Setup.
• MIDI In/Out: MIDI out connects to external MIDI
devices to send MIDI from the PianoBar to the
external device. MIDI In is connected to the
MIDI out of an external MIDI device to receive
MIDI data. The current Setup determines how
MIDI channels 1-16 are routed, externally and
internally. These are set in Channel Setup and
Channel Route.
• Scanner Bar In: Connects to the Scanner Bar to
receive the Piano’s Performance data. Note:
Although this is a standard USB connector, this
is not a USB device.
• Pedal Sensor In: Connects to the Pedal Sensor
to receive signals from the sustain and soft
pedals. Note: Although this is a standard USB
connector, this is not a USB device.
• Audio Outputs: Two ¼” jacks deliver the audio
output of the PianoBar’s internal sounds to your
amplification.