User Guide

13
2) For the outside sections of the Scanner Bar,
locate the thumbscrews on the front. Loosen them.
Adjust the outside sections so the alignment marks
line up with the gaps between their respective Bs
and Cs. Once the alignment marks are set, tighten
the thumbscrews.
3) Place the Library card face up on the lowest B
and C so the handle points towards the back of
the piano. Use the left leveling system to adjust the
height of the scanner so it barely touches the top
of the library card.
4) Place the library card in a similar position on the
highest B and C. Use the right leveling system to
adjust the height of the right side of the scanner.
5) Plug the longer of the two provided cables into
the Pedal Sensor. Place the Pedal sensor under the
piano’s pedals so the cable comes out the back.
When either the Soft Pedal or the Sustain Pedal are
depressed, they should be approximately ½” to 1”
above the pedal sensor, adjust height if necessary.