Operating instructions

WIRELESS SETUP
Once the dome is installed and power is connected to it, the wireless master
unit must be installed. Below is the basic setup for the master RF unit. Please
see the antenna installation section for proper antenna usage.
BASIC SETUP
1. Plug in the AC Power to the Power over Ethernet Injectors
2. Plug in the CAT5 cable from each WIRELESS UNIT into the injectors.
(NOTE: This unit can use both crossover cable and straight patch through cables.)
3. Connect the Ethernet cable from each injector into the Ethernet.
4. Use site survey mode to orient the antenna direction, and if necessary
manually select the best channel
LED Name Function Color
1 Power Unit has power and has successfully booted. Red
2 RF Link The radio has successfully linked with its
partner.
Green
3 RF TX Radio transmission is occurring. Green
4 RF RX Radio reception is occurring. Green
5 Eth Link The Ethernet Port has a valid Ethernet
connection
Green
6 Activity The WIRELESS UNIT is processing data Green
7 1
channel)
By adding the numbers that are lit the user
can determine the current radio channel.
1 903 MHz
2 905 MHz
3 907 MHz
4 909 MHz
5 911 MHz
6 913 MHz
7 915 MHz
8 917 MHz
9 919 MHz
10 921 MHz
11 923 MHz
12 925 MHz
Green
8 2
channel)
9 4
(channel)
10 8
channel)
11 Link Quality Excellent link quality – No retransmissions Green
12 Link Quality Very good link quality – Few retransmissions Green
13 Link Quality Good link quality – Some retransmissions Amber
14 Link Quality Fair link quality – Many retransmissions Amber
15 Link Quality Weak link quality – Some packet failures Red
16 Link Quality Poor link quality Red
Master Wireless Unit
Each WIRELESS Master pair automatically selects the best radio channel,
encrypts the Ethernet trafc and transports the data wirelessly to and from
the wireless dome.
The wireless unit functions in place of an Ethernet cable and provides a
transparent wireless point-to-point Ethernet cable replacement. Crossover
cables are not necessary as the WIRELESS UNIT automatically senses the
device (client or switch).
LED display:
Once the unit is operational, you should see the following colors on the LEDs
of the wireless unit.
The WIRELESS UNIT has a 16 LED display (see above chart) to display the
status of the device.