Operating instructions

Please read these instructions carefully before proceeding,

and heed all cautions.

STANDARD INSTALLATION PROCEDURE

INCLUDES MODELS: P1800

NOTE: If you'll be using the optional PV4 anchor jig, see

the attached instructions for assembly of the jig.

Part 1: Site Preparation

NOTE: Special attention must be paid to the size of the wiring

conduit and its location within the concrete foundation and jig (if

applicable.) The Wiring Conduit can be up to 2" in diameter.

Use reducers if necessary. Also, make sure that the Wiring

Conduit is in the center of the foundation and Anchor

Jig during installation (Figure 1).

1" diameter

maximum

Figure 1

Wiring conduit

1. Select a suitable site for the P1600 and prepare the pad site using a hole 36"

x 36" x 36" deep. The top of the concrete foundation should be ush with the

ground.

CALL BEFORE DIGGING! Be sure that there are no

underground electric or phone cables, gas or water

lines in the area where the pole will be located.

CAUTION: To prevent corrosion; never use galvanized hardware with

the stainless steel hardware.

2. To help reinforce the concrete foundation, place (12) 1/2" diameter x 32" long

Reinforcement Bars ("rebar") as shown in Figure 2. Use suitable preparation

methods to place the rebar.

24"

36"

24"

36"

24"

32"

12"

32"

36"

Figure 2

Reinforcement bars (12)

PV4 Anchor jig (if applicable)

Up to 2" in

diameter