Operating instructions

Anchor Jig Assembly

Anchor Jig Kit Parts List

Single Straps (4)

Cross Strap (1)

3/4" - 10 Bolts (4)

3/4" Flat Washers (4)

3/4" - 10 Hex Nut (20)

Lock

Washers (4)

1. Thread two (2) nuts onto each of the (4) bolts (Figure 1). The end with 6" of

clearance will be the top of the Anchor Jig, the end with 1 ½" clearance will be the

bottom.

NOTE: Because of surface conditions it may be necessary to use leveling nuts. See

step 5 below for information.

NOTE: The Flat Washers, Lock Washers, and remaining Hex Nuts will be used to

fasten the pole to the Anchor Jig.

4. Before using the Anchor Jig verify that the center to center dimensions between

the bolts are even (Figure 4). If not, adjust accordingly. Firmly tighten all Hex Nuts.

With Leveling Nuts

Without Leveling Nuts

/2"

18"

Figure 1

2. Place the short end of each Bolt into the outside holes of the Cross Strap. Place

Hex Nuts onto each Bolt and nger tighten (Figure 2).

3. Turn the Anchor Jig over and place Single Straps over the Bolts (Figure 3). Use

the inside hole of each strap. Place Hex Nuts onto each Bolt and nger tighten.

Figure 2

Figure 3

/32"

11"

diameter

Figure 4

5. If, due to conditions or other requirements, leveling nuts are needed, adjustments

will have to be made to the Anchor Jig. Below are diagrams comparing the

Anchor Jig with and without leveling nuts. Leveling nuts and washers are NOT

provided with the pole,

CAUTION: TO PREVENT CORROSION; NEVER MIX GALVANIZED

HARDWARE WITH STAINLESS STEEL HARDWARE!