User`s manual
MP-201 User’s Manual
Page 8
MP-201 User’s Manual
Page 9
The Multi-Pedal is now congured as a
standard expression pedal with a Control
Voltage (CV) range of 0 to +5V. If you are
connected to a Voyager or Little Phatty,
playing the keyboard while adjusting the
footpedal will open and close the lter. If
you are connected to a Moogerfooger
pedal, playing your instrument while adjust-
ing the footpedal will change the related
Moogfooger parameter (Cutoff, Rate, Freq,
etc.).
4. On the Multi-Pedal, use the VALUE encoder to select Preset 01
‘REVERSE4’. This time the Multi-Pedal is congured as expression
pedal that works in reverse, where the maximum value is in the heel
position and the minimum value is the toe position.
5. On the Multi-Pedal, use the VALUE encoder to select Preset 02
‘TRIANGLE’. The Multi-Pedal is now congured to output a Low
Frequency Oscillator (LFO) Triangle wave CV where the footpedal
is congured to control the speed (RATE) of the LFO.
6. Presets 03 thru 08 offer variations of LFOs (square, sawtooth,
sample & hold, etc.). Feel free to experiment with all of them, and
then try some different patch routings with the Moogerfoogers or
Voyager/Little Phatty.
3. On the Multi-Pedal, use the VALUE encoder to select Preset 00
‘EXPRESSR’. The Multi-Pedal LCD should appear as shown below.
For MIDI Control -
If you are a MIDI musician, try the following example:
1. Plug the other end of the MIDI cord from the MP-201 to the MIDI IN
jack of your MIDI Instrument or MIDI Device.