User's Manual

page 25
Figure 13 - Power Input Connector
TECHNICAL INFORMATION
NOTE: The following information is intended for use by people who
understand analog electronic circuitry and have enough practical
experience to interconnect sophisticated electronic equipment correctly.
FIRMWARE UPDATE VIA MIDI: The MF-105M can be enabled
to receive MIDI SysEx data containing the Operating Firmware for
the MIDI MuRF by powering up in what is called "Bootloader Mode".
This is done by setting the LFO and FREQ switch in the rightmost
position and pressing the Bypass switch while the unit is powered up.
The Drive and Bypass lights will blink, followed by all LEDs lighting
up green. This indicates the unit is in Bootloader Mode and can be
sent rmware via a MIDI connection. More information about this
feature as well as tools for downloading rmware can be found on the
www.moogmusic.com website.
POWER: The MF-105M works on +9 volts DC and uses a max of
about 240 milliamperes of current. Use only the power supply supplied
with the MF-105M or the exact equivalent. Power sources rated with
voltages in excess of +9 Volts may cause damage to the MF-105M’s
circuit.