User's Manual

Moog Components Group • www.moog.com/components
7
Transducers
Transducers have been employed on both
military and commercial aircraft to provide
position feedback information of flight
control surfaces to the ight computers,
autopilots and cockpit displays.
Model 800-XX
Our Model 800 Series Position
Transmitter monitors the stabilizer position
of the Boeing 757 and 767 commercial
aircraft.
• Input voltage: 28 VRMS, 400 Hz
• Position switches (up to 6)
• Rotary variable differential transformer
(RVDT)
• 1 speed synchro
• Flame arrestor
• Anti-backlash gearing
• Robust structural design
• High efciency steel gearing
• Size: 4 inch OD x 5.2 inches long
Model 932-02
The Model 932-02 is designed for shaft
position sensing such as aileron and
elevator cable position on the C5 military
transport.
• Input voltage: 26 VAC, 400 Hz
• Consists of 3 synchros and input shaft
• 1:1 gearing
• Single electrical connector for interfacing
the excitation voltages and the synchro
output signals
Linear Actuators - Ampliers - Transducers
Model 933-01
The ap position
transducer is used in
C-5 military transports
to convert the
mechanical position of
the aps to appropriate
electrical signals for position indication.
• Input voltage: 26 VAC, 400 Hz
• Consists of 2 synchros and input shaft
• 4:1 gearing
• Single electrical connector for interfacing
the excitation voltages and the synchro
ouput signals
Model 943-XX
The Model 943 Position
Transmitter monitors
the stabilizer position
of the Boeing 747- 400
commercial aircraft.
• Input voltage: 28 VRMS, 400 Hz
• Rotary variable differential transformer
(RVDT)
• 1 speed synchro
• Flame arrestor
• Anti-backlash gearing
• Robust structural design
• High efciency steel gearing
Model 976
The Model 976 position transducer
monitors the position of the nacelle of
an unmanned aerial vehicle (UAV).
• Voltage 6 VAC, 3000 Hz
• 5:4 gearing
• Consists of two rotary variable
differential transformers (RVDT)
• Single electrical connector for
interfacing the excitation voltages and
RVDT output signals
• Size: 3.88 x 4.75 x 14.75 inches long
• Power: 28 VDC
• Rated power point: 1500 lb @ 0.26 in/sec
• Weight: 8.1 lbs
• Two NFeB Permanent Magnet DC brush
motors
• Two failsafe electromagnetic brakes
• Robust structural design
• Low endplay
• High efciency steel gearing
• Trunnion mount for xed end and traveling
nut endtting
• Ball screw/nut power screw assembly
• Stroke: 7.25 inches electrical stroke
• No-load speed: 0.87 in/sec
Ampliers
Amplifiers are used to
control the actuators when
the drive electronics are
located seperately outside
the actuators.
Model 871-01
150 VDC transconductance amplier
used with the Model 873 Rotary Actuator.
Model 911-01
270 VDC brushless motor controller for a
pump system on a military armored vehicle.
Model 944-01
150 VDC transconductance amplier
used with the Model 875 Rotary Actuator.
Model 962-01
150 VDC transconductance amplier
used with the Model 961 Rotary Actuator.
Linear Actuators / Ampliers / Transducers