Service manual

- 11 -
Section VII: Adjustment Procedures and Locations
Each time a Mini-Moog is serviced, it should be tuned. When a board has been replaced it will
be necessary to make additional adjustments. Refer to the table below to determine which
adjustments must be made according to the board that has been replaced.
WHEN REPLACING MAKE THESE ADJUSTMENTS
93-113 (Board 1) Oscillator 1. Oscillator 1, 2, and 3 tuning
2. Octave range trimmer
93-114 (Board 2) Contour Generator 1. Check tuning (adjust if necessary)
93-115 (Board 3) Power Supply 1. +10 volts
2. -10 volts
3. Noise level
4. Check tuning (adjust if necessary)
93-116 (Board 4) Filter 1. VCA balance (1 and 2)
2. A-440 frequency
3. Regeneration cal.
4. Filter range
5. Filter scale
93-060 Left Hand Controller 1. Check tuning (adjust if necessary)
93-061 Keyboard 1. Check tuning (adjust if necessary)