Specifications

MN00178 1359
Specications
PAN & TILT
TInput Voltage 10 to 30 VDC
Power Requirements Positioner w/Visible camera requires 60W during initialization or at start of move,30W during continuous motion, 11W at idle. If heaters
are activated, an additional 72W is required. The FLIR Tau camera used in thermal imager models requires an additional 1.2W
(approximate). Illuminator requires 45W, provided on separate power leads
Pan Range Continuous pan rotation, non-continuous selectable. Soft limits adjustable for non-continuous pan, no soft limits for continuous pan
Pan Speed Range 0.25º to 100º /sec with QuickShift® technology
Tilt Range Mounting Soft limits adjustable to ±90º max. (180º total) from horizon (parallel to P&T surface.) Factory default setting is 90º down, 90º up. Hard
stops set approximately ±95°
Tilt Speed Range 0.25º - 100º / sec. with QuickShift® technology
Motor Type Stepper motors are used for both Pan and Tilt axis
Wiring 26 Pin Connector on bottom of unit
System Dimensions (H x W x D) 7.25" x 14.25" x 10.5" (185 x 362 x 266.7mm)
System Weight 24 lbs. (10.9 kg) approximately with dual cameras
Drivetrain Belt driven stepper motors with high torque timing belts
Tilt Limit Internal, xed stops, adjustable soft limits
Repeatability 0.25º
Material Housings - Aluminum, Hardware - Stainless Steel
Exterior Color / Finish White Marine Powder Coated (other colors & custom colors/private labeling upon request)
Environmental Enclosure Gasketed & sealed, IP-66 rated
Operating Temperature -40˚ to 122˚F (-40˚ to 50˚C) with heaters
Position Feedback Motor pulse count and optical position sensors, position resolution to 0.01º.
CAMERA HOUSING
Environmental Enclosure O-ring seals and pressurizable (5 psi max)
Heaters Camera housing heater(s) (thermostatically controlled)
Hardware/Wiring Stainless hardware and concealed wiring
CONTROL
Communication modes: Ethernet TCP/IP for each camera and positioner control. Supports QuickSet PTL-11 and Pelco-D Extended command & control protocols,
Camera interface board required for each specic camera. Basic test software for Windows™ provides capability to congure, test, and
operate the Pan & Tilt 32 Preset positions - each storing azimuth, elevation, zoom, & focus. 2 tours of 63 steps of 32 presets with easy
insert editing capability. Capability of entering absolute angle offsets to align pan and tilt platform to user coordinate base. Align local
coordinates to global coordinates. Automatic calibration as required using internal optical position sensors.
™
Windows and
Microsoft are registered trademarks of Microsoft Corporation.