User`s manual

CHAPTER 3.0 Wiring and Installation 3-52
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
3.11.2.1 Drive Ready Relay
The DS2110 provides 1 relay output on connector J2C. This relay closes when the drive is ready and no faults
are present.
- Fixed connector: 2 pins, male connector
- Mating connector, 2 pins spring cage, female, supplied with the drive. Phoenix Contact (Part # FK-MC 0.5/2-
ST-2.5)
- Wiring: cable. 28-20AWG (0.14-0.5mm
2
)
- Wire stripping: 8 mm
Pos. Name Function
J2C.1 Drive Ready 1 Drive ready relay contact pin 1 Drive Ready Relay Contact
J2C.2 Drive Ready 2 Drive ready relay contact pin 1 Drive Ready Relay Contact
Table 3. -26 J2B, DS2110 Digital Output connector
The following electrical description applies to the Drive ready relay of the DS2110.
J2C.1
Drive Ready 1
Drive Ready
Relay
J2C.2
Drive Ready 2
5V
Figure 3.45 Drive Ready Relay Output
Note that:-
 Closed when drive ready and no faults.
 Max. voltage 36 V
 Max. contact current 100 mA