User`s manual

CHAPTER 3.0 Wiring and Installation 3-35
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
3.9.5 E Size Regeneration Resistor connection
Tie screen to
panel on
which resistor
is mounted.
Tie Screen to
chassis via EMC
bracket. See
Section 2
Installation
J9.4 J9.3
+ATP RR
Connector J9
DS2110 E
Recovery
Resistor
Figure 3.29 DS2110 Size E External Regeneration Connections
J9
- Fixed connector: 2 pole, screw terminal
- E size wiring: cable 2 AWG (34 mm
2)
- Stripping Length 19mm
- Tightening Torque: 4Nm
Pos. Name Function
J9.3 RR Regeneration Resistor
J9.4 +ATP DC Bus (+)
Table 3. -14 J9, Regeneration Resistor connector, E Size
WARNING - When performing any changes to the regen resistor configuration, a.c. input
power must be removed from the DS2110. Wait at least 5 minutes for the A sizes (6
minutes for the A-E sizes ) upon removal of all power, to allow for D.C. Bus capacitors to
discharge.