User`s manual

CHAPTER 2.0 Safety & EMC Instructions 2-14
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
L1
The following table details the mechanical dimensions of the recommended filters.
Manufacturer Dimensions
[mm]
Weight
Moog
Order
Code
L1 L2 L3 L4 L5 L6 L7 [kg]
AT6017
Schaffner
FN2070-3-06
85 75 54 0 65 40.3 Fast-on 0.25
AT6009
Schaffner
FN 258-7/07
255 240 50 25
225
±0.8
126
±0.8
300 1.1
-
Schaffner
FN350-12/29
99.5 51 105 95 99.5 57
Terminal
blocks
only
0.9
AT6010
Schaffner
FN258-16/07
3.5 290 55 30
275±0.
8
142±0.
8
300 1.7
AT6011
Schaffner
FN258-30/07
335 320 60 35 305 150 400 1.8
AT6012
Schaffner
FN258-42/07
329 314 70 45 300 185 500 2.8
AT6013
Schaffner
FN258-55/07
329 314 80 55 300 185 500 3.1
AT6015
Schaffner
FN258-100/35
379 364 90 65 350 220
Terminal
blocks
only
5.5
TOP VIEW SIDE VIEW
Table 4 - DS2110 Recommended Filters Mechanical Sizing
The filter must be located as close as possible to the drive input. If the separation between filter and drive
exceeds 30 cm (1’) , then a flat cable (multi-thread copper flat cable) should be used for the RF connection
between filter and drive.
L2
L4 L3
L6
L5
L
7
Requi red for
CE-Compliance
Caution: A space of at least 60mm (2.4”) must be left around the filter for
air circulation when the cabinet does not have forced ventilation.
Before mounting the drive and the filter to the cabinet, check that the panel
surface is conductive. If not, remove any paint and/or other insulating
material before mounting the drive and filter.