User`s manual

APPENDIX B – GUI B-49
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
B.2.16.54 Fieldbus Status Byte 1
FIELDBUS STATUS BYTE 1:
• Generic fault → Indicates communications failed to initialize, Asynchronous transmissions could not be sent or
a Keylock loop error.
• Sync fault → Indicates erroneous bus activity.
B.2.16.55 Input Monitor Status Byte
INPUT MONITOR STATUS BYTE:
• Fault Override → Indicates faults have been overidden.
• Safety Circuit monitor → Indicates the status of the safety circuit monitor.
• Restart I/L Output fault → Indicates the status of the safety circuit input monitor.
• Restart I/L enable fault → Indicates that a safety circuit input monitor signal was not present when the drive
was commanded to be enabled.
• Brake Monitor fault → Indicates that the brake monitor is not consistent with the commanded state of the
brake