User`s manual

APPENDIX B – GUI B-41
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
B.2.16.40 Board Status Byte 1
DIGITAL BOARD STATUS BYTE 1 :
• FPGA Configuration Transmission → Indicates if there is a fault in FPGA configuration transmission.
• DSP Programming → Indicates there is a DSP programming fault.
• QSPI Loopback → Indicates there is a QSPI loopback fault.
• Ambient over temperature → Indicates that the ambient temperature is greater than the programmed limit.
• Ambient Thermal Foldback Warning → Indicates that the ambient temperature has reached 90% of the set
temperature at which point thermal limiting begins.
• Ambient Thermal Warning → Indicates that the ambient temperature has reached 90% of the set temperature
at which a thermal fault occurs.
B.2.16.41 Board Status Byte 2
DIGITAL BOARD STATUS BYTE 2 :
• COM1 loopback → The result of the loop back test performed during initialisation of the drive.
• COM1 initialisation → The result of the COM port initialisation