User`s manual

APPENDIX B – GUI B-32
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
B.2.16.31 Digital Output Configuration
The Digital Output Configuration panel allows the user to set digital output parameters.
There are 3 digital outputs on the DS2110. All 3 outputs are user-configurable.
DIGITAL OUTPUT CONFIGURATION :
DIGITAL OUTPUT (1, 2, 3)
• Parameter Number → The specific parameter to be associated with the digital output. The field value of the
parameter must be entered into the digital output field number parameter, to specify the parameter of interest.
9 Digital Output 1 defaults to drvsts
9 Digital Output 2 defaults to limact
9 Digital Output 3 defaults to diginp
• Bit Mask → Specify bits used to determine state of digital output within the parameter. This mask is ANDED
with the parameter specified by the field number to determinate the digital output state.
• Invert → Invert the logic of the digital output.