User`s manual

CHAPTER 5.0 Functional Overview 5-7
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
5.3.6 Power Interface Parameters
Parameter Name
Field
Number
Data
Type
Access
Default
Value
Min.
Value
Max.
Value
Units
Storage
Type
Data
Group
HIGH VOLTAGE
bus_voltage_actual 1232 f32 r - - - V N A
bus_voltage_nominal 1229 f32 r - - - V N A
bus_under_voltage_limit 1234 f32 r - - - V N A
bus_under_voltage_limit_percentage 1235 f32 r/w 75 0 100 % C A
bus_over_voltage_limit 1233 f32 r/w 800 0 1000 V C A
LOW VOLTAGE
supply_+24V 1441 f32 r - - - V N A
supply_+3V3 1421 f32 r - - - V N A
supply_-15V 1426 f32 r - - - V N A
supply_+15V 1431 f32 r - - - V N A
supply_+2V_ref. 1436 f32 r - - - V N A
encoder_supply 1446 f32 r - - - V N A
REGENERATION CONTROL
regen_enable 1268 U16 r/w 1 0 4 - C A
regen_on_voltage 1249 f32 r/w 780 10 - V C A
regen_off_voltage 1248 f32 r/w 760 0 - V C A
regen_power_filtered 1252 f32 r - - - W N A
regen_internal_resistance 1258 f32 r/w see note 1 0 - Ohm F A
regen_internal_resistor_power 1259 f32 r/w see note 1 0 - Ohm F A
regen_internal_resistor_initial_on_time 1261 f32 r/w 20 - ms F A
regen_internal_resistor_continuous_on_time 1260 f32 r/w 2 - ms F A
regen_external_resistance 1262 f32 r/w 0 0 - Ohm C A
regen_external_resistor_power 1263 f32 r/w 0 0 - Ohm C A
regen_external_resistor_initial_on_time 1265 f32 r/w 20 - ms F A
regen_external_resistor_continuous_on_time 1264 f32 r/w 2 - ms F A
regen_power_capability 1269 f32 r - - - W N A
regen_max_current 1266 f32 r/w see note 2 0 - A F A
Table 5.5 Power Interface Parameter Access Detail
Note 1: The internal regeneration capability is automatically determined from the power stage at initialisation
Note 2: The regeneration maximum current capability is automatically determined from the power stage at initialisation