User`s manual

DS2100 User's Manual SECTION 3: WIRING AND INSTALLATION
PAGE 3-48 C27750-001
3.11.2 Motor Power Cable
Wire the motor power connector in accordance with Figure 3.3.35 to Figure 3.3.42.
Use wire sizes based on the motor’s continuous stall current (r m s) and wire length requirements.
For proper drive commutation of motors, it is required that the motor phase conductors, Phase U, Phase V , and Phase
W be wired exactly.
Wiring must be in accordance with standard EN 60204-1 (See Section
2 of this Users Manual.)
Required for
CE-Compliance