User`s manual

DS2100 User's Manual SECTION 3: WIRING AND INSTALLATION
PAGE 3-46 C27750-001
3.10.5 E Size Regeneration Resistor connection
Tie screen to
panel on
which resistor
is mounted.
Tie Screen to
chassis via EMC
bracket. See
Section 2
Installation
J9.4 J9.3
DC+(RR) RR
Connector J9
DS2100 E
Recovery
Resistor
Figure 3.3.34 DS2100 Size E External Regeneration Connections
J9
- Fixed connector: 2 pole, screw terminal
- E size wiring: cable 2 AWG (34 mm
2)
- Stripping Length 19mm
- Tightening Torque: 4Nm
Pos.
Name
Function
J9.3 RR Regeneration Resistor
J9.4 DC+(RR) DC Bus (+)
Table 3.3-19 J9, Regeneration Resistor connector, E Size
WARNING - When performing any changes to the regen resistor configuration,
a.c. input power must be removed from the DS2100. Wait at least 5 minutes for
the µA sizes (6 minutes for the A-E sizes ) upon removal of all power, to allow
for D.C. Bus capacitors to discharge.