User`s manual

APPENDIX B: GUI DS2100 User's Manual
C27750-001 PAGE 57
B.3.16.42 Generic Filters
The Generic Filters panel allows the user to set the 9 programmable parameters of the filter on the output
of the velocity compensator.
It may be configured as hi-pass, low-pass, band-pass or band-stop, to allow for maximum flexibility.
The filter is used in the velocity loop and the output of the velocity compensator becomes the input to the
generic filter.
GENERIC FILTER PARAMETERS :
• Filter Coefficients → these can be set individually or else the filter coefficient calculator can be
used to derive the coefficients for a requested filter response.
• Filter Mode → Allows the user to choose the filter mode between high/low pass and band
pass/stop. This is used in the drive to reduce the amount of calculation performed when high/low
pass is selected.
The ‘Calculator’ button starts the filter coefficient calculator
The ‘Update from calculator’ button will place the values calculated by the filter coefficient calculator
into the filter coefficient boxes ready to write to the drive. They will not be written to the drive until
explicitly requested.