User`s manual

APPENDIX B: GUI DS2100 User's Manual
C27750-001 PAGE 37
FEEDBACK PARAMETERS → Allows the user to see the value of the four feedback parameters.
The parameters are:
• Position Demand Value → Output from Demand Block in position units.
• Position Demand Value* → Output from Demand Block in units of increments.
• Position Actual Value → Actual value from the position measurement device, in position units.
CONTROL WORD BITS
• Homing Operation Start → Activate the homing mode.
• Halt → Allows the user to set/clear the halt bit.
STATUS WORD BITS
• Target Reached → It shows if Home position is reached.
• Homing Attained → It shows if Homing mode is successfully completed.
• Homing Error → It shows if a Homing error has occurred.