User`s manual

DS2100 User's Manual SECTION 2: SAFETY & EMC INSTRUCTIONS
PAGE 2-18 C27750-001
L1
The following table details the mechanical dimensions of the recommended filters.
Manufacturer Dimensions
[mm]
Weight Moog
Order Code
L1 L2 L3 L4 L5 L6 L7 [kg]
AT6017 Schaffner
FN2070-3-06
85 75 54 0 65 40.3 Fast-on 0.25
AT6009 Schaffner
FN 258-7/07
255 240 50 25 225
±0.8
126
±0.8
300 1.1
- Schaffner FN350-
12/29
99.5 51 105 95 99.5 57
Terminal
blocks only
0.9
AT6010 Schaffner FN258-
16/07
3.5 290 55 30
275±0.8 142±0.8
300 1.7
AT6011 Schaffner FN258-
30/07
335 320 60 35 305 150 400 1.8
AT6012 Schaffner FN258-
42/07
329 314 70 45 300 185 500 2.8
AT6013 Schaffner FN258-
55/07
329 314 80 55 300 185 500 3.1
AT6015 Schaffner FN258-
100/35
379 364 90 65 350 220
Terminal
blocks only
5.5
TOP VIEW SIDE VIEW
Table 2.4 DS2100 Recommended Filters Mechanical Sizing
The filter must be located as close as possible to the drive input. If the separation between filter and drive exceeds 30 cm
(1’) , then a flat cable (multi-thread copper flat cable) should be used for the RF connection between filter and drive.
L2
L4 L3
L6
L5
L7
Required for
CE-Compliance
Caution
: A space of at least 60mm (2.4”) must be left around the filter for
air circulation when the cabinet does not have forced ventilation.
Before mounting the drive and the filter to the cabinet, check that the panel
surface is conductive. If not, remove any paint and/or other insulating
material before mounting the drive and filter.