User`s manual

DS2100 User's Manual SECTION 2: SAFETY & EMC INSTRUCTIONS
PAGE 2-16 C27750-001
2.3 Electromagnetic Compatibility (EMC)
The DS2100 Servo-drive are system components which must be installed in a correct manner to ensure that all
electromagnetic compatibility (EMC) requirements are met. The requirements of European Union (EU) EMC Directive:
89/336/EEC (as amended by EU Directives 92/31/EEC and 93/68/EEC ) must be met by all equipment, systems and
installations into which the DS2100 Servo-drive are installed.
For further information on the requirements of EU EMC Directive the user is recommended to refer to the latest
publications of the EU Commission and to local regulations.
The DS2100 Servo-drive have been tested for compliance with the requirements of the EU EMC Directive in so far as
they can be regarded as single functional units. The DS2100 have been tested in typical configurations and it has been
found that these configurations meet the essential requirements of the EU EMC Directive. The EMC standards applied is
EN61800-3:
This standard is published by CENELEC, the European Committee for Electrotechnical Standardisation, Brussels.
2.3.1 Specific Electromagnetic Compatibility (EMC) Requirements:
The EMC measures outlined below are required to be installed by the user into all equipment, systems and installations
into which the DS2100 is installed. Further details are given throughout this User’s Guide.
The DS2100 Servo-drive must be installed by mounting on a panel in a manner that ensures that EMC earthing
requirements are met. (Refer Section 3 of this User’s Guide).
EMC brackets are provided to facilitate earthing of cable shields prior to entering the DS2100. Cable shields must be
bonded to either the panel earthing bar or the EMC brackets.
For safety reasons the DS2100 Servo-drive, and the panel on which they are mounted must be installed in enclosures or
cabinets which provide a degree of ingress protection against liquids and objects of at least IP54. These enclosures or
cabinets must be accessible to technically qualified service or maintenance persons only.
For Electrostatic Discharge (ESD) reasons all service or maintenance persons must ground themselves to the chassis of
the equipment when performing service functions inside the IP54 rated enclosure or cabinet in which the DS2100 Servo-
drive are installed.
All external d.c. supply voltages used with the DS2100 must be supplied from power supplies which are compliant with
the requirements of the EU EMC Directive. All other equipment that is connected to the DS2100 must be compliant
with the EU EMC Directive.
User's whose machine installations are intended for CE-
Compliance should read this Section.
Required for
CE-Compliance