User`s manual

DS2100 User's Manual
SECTION 4: GETTING STARTED
PAGE 4-22 C27750-001
4.16 Power-Down Sequence
Ensure the drive is disabled and remove Hi Power (AC mains) from the DS2100 controller. Wait until the DC Bus
Voltage has decreased to below 50VDC before servicing the controller, “
DS2100 → DC Bus Monitoring → Detected
DC Bus Voltage”.
Close the Oscilloscope and the Windrive GUI and remove the 24V DC Logic Back up from the DS2100.
The sequence outlined in the preceding sections provides the user with step by step procedure on how to operate a
DS2100 controller using the Windrive software performing basic motoring operations.
For a more in depth analysis of the DS2100 and Windrive Software please consult the relevant sections of the DS2100
User’s Manual and the GUI User’s Manual.