Specifications

Page 34
LP User’s Manual - The User Interface
Page 35
LP User’s Manual - The User Interface
FIRMWARE DUMP
This option allows you to backup the operating system via SysEx data.
To execute this command, enable the device that is to receive the
SysEx data. Once you have enabled your remote SysEx device, press
ENTER
to start the data transfer.
When
ENTER
is pressed, the LCD will display the ‘SENDING FIRM-
WARE SYSEX’ message shown, and the
ENTER
button will stay lit until
the SysEx transfer is complete When the operation has  nished, the
display will return to the SYSEX menu.
Receiving SysEx Data
The LP is able to receive System Exclusive data at any time without any special prior setup. SysEx  les are
recognized and received automatically when a SysEx data transfer is initiated. The Little Phatty’s LCD screen
will display the status of SysEx data transfers as follows:
SINGLE PRESETS:
The LP will brie y display a ‘RECEIVING SINGLE PRESET’ message
whenever a single preset is transmitted via SysEx. The preset will
automatically be stored at the current preset location. For example, if
the current preset location is 31 when the SysEx is received, the new
preset data will be written into location 31.
ALL PRESETS:
The LP will display a ‘RECEIVING ALL PRESETS’ message when a bank
of presets is transmitted. The transmitted bank will replace the current
bank.
BULK DUMP:
The LP will display a ‘RECEIVING BULK DUMP’
message when a bulk
dump is transmitted.
FIRMWARE UPDATES:
The LP will display a ‘RX FIRMWARE’ message when a  rmware
update is transmitted. Additional status messages may appear on the
second line of the display as the transmission executes. After the  rm-
ware update is completed, the LP will automatically reset.