Instruction manual

ManualsBrandsMoog Videolarm ManualsSecurity CamerasRHP75C2N

www.videolarm.com

R H W 7 5

Vandal-Resistant Rugged (Outdoor Dome Housing)

Installation and Operation Instructions for the following models:

RHW75C2N IP Network Ready 7” Vandal-Resistant Outdoor dome housing with wall mount,

rugged cast aluminum top and polycarbonate clear dome, with 24VAC input,

heater/blower, for an IP Network PTZ camera, 120 to 24VAC transformer.

RHP75C2N IP Network Ready 7” Vandal-Resistant Outdoor dome housing with pendent mount,

rugged cast aluminum top and polycarbonate clear dome, with 24VAC input,

heater/blower, for an IP Network PTZ camera, 120 to 24VAC transformer.

IRHW75C2N IP Network Ready 7” Vandal-Resistant Indoor dome housing with wall mount, rugged cast

aluminum top and polycarbonate clear dome.

IRHP75C2N IP Network Ready 7” Vandal-Resistant Indoor dome housing with pendent mount,

rugged cast aluminum top and polycarbonate clear dome.

IRHW7C Vandal-Resistant Indoor dome housing with wall mount, rugged cast aluminum top

and polycarbonate clear dome.

RHW75C2NE IP Network Ready 7” Vandal-Resistant Outdoor dome housing with wall mount,

rugged cast aluminum top and polycarbonate clear dome, with 24VAC input,

heater/blower, for an IP Network PTZ camera, 120 to 24VAC transformer.

(European Model)

Before attempting to connect or operate this product, please read these instructions completely.

To be used with the 81-IN5481 Instruction Manual.

W81-IN5309

01-10-2012

Summary of content (24 pages)

PAGE 1
© 2011, Moog Videolarm, Inc. All Rights Reserved RHW75 Vandal-Resistant Rugged (Outdoor Dome Housing) www.videolarm.com Installation and Operation Instructions for the following models: RHW75C2N IP Network Ready 7” Vandal-Resistant Outdoor dome housing with wall mount, rugged cast aluminum top and polycarbonate clear dome, with 24VAC input, heater/blower, for an IP Network PTZ camera, 120 to 24VAC transformer.
PAGE 2
IMPORTANT SAFEGUARDS 1 Read these instructions. 2 Keep these instructions. 3 Heed all warnings 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with damp cloth. 7 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8 9 SAFETY PRECAUTIONS Cable Runs- All cable runs must be within permissible distance.
PAGE 3
Limited Warranty for Moog Videolarm Products Moog Videolarm warrants these products to be free from defects in material or workmanship as follows: PRODUCT CATEGORY PARTS \ LABOR All Enclosures and Electronics* Five Poles/PolEvators™/CamEvator Three (3) Years Warrior Series™/Q-View™/IR Illuminators Five (5) Years SView Series™ Five (5) Years **6 months if used in auto scan/tour operation Controllers Five (5) Years Power Supplies Five (5) Years EcoKit Three (3) Years Accessory Brackets F
PAGE 4
! English Español Français Deutsch Portuguese Italiano Electrical Specifications Contents of Box RHW75 Power 24VAC Class 2 Only 24 VAC 92 Watts Accessories: Heater: 50 Watts, Blower: 2 Watt Camera Power: (See Camera Specifications): 40 Watts Max Tools Required: .
PAGE 5
1 WALL MOUNTING 2 4”-5” Bracket is designed for 45° conduit fitting (If using the conduit). Run wire into bracket secure to wall. • El soporte se diseña para la guarnición del conducto 45° (si usa el conducto). Funcione con el alambre en el soporte seguro para emparedar. • La parenthèse est conçue pour l'ajustage de précision du conduit 45° (si à l'aide du conduit). Courez le fil dans la parenthèse bloquée pour murer.
PAGE 6
5 6 WALL MOUNTING ! 40 Watts 26 Watts C Important Gasket Must be in place COAX (coax wire not supplied) Wiring the dome can be completed by referring to the diagram. • Atar con alambre la bóveda puede ser terminada refiriendo al diagrama. • Le câblage du dôme peut être accompli en se rapportant au diagramme. • Das Verdrahten der Haube kann durchgeführt werden, indem man auf das Diagramm sich bezieht. • Wiring a abóbada pode ser terminado consultando ao diagrama.
PAGE 7
9 FOR PENDENT/ WALL MOUNTING 10 4”-5” Trim incoming control and power wires to 4-5” for either wall or pendent bracket. • Ajuste los alambres entrantes del control y de la energía a 4-5” para la pared o el soporte pendiente. • Équilibrez les fils entrants de commande et de puissance à 4-5 » pour le mur ou la parenthèse en suspens. • Trimmen Sie ankommende Steuer- und Energiendrähte bis 4-5“ entweder für Wand oder pendent Haltewinkel.
PAGE 8
13 14 Important Gasket Must be in place ! Align large arrows. To lock turn clockwise. • Alinee las flechas grandes. • Alinee las flechas grandes. • Alignez les grandes flèches. • Alignez les grandes flèches. • Richten Sie große Pfeile aus. • Richten Sie große Pfeile aus. • Alinhe grandes setas. • Alinhe grandes setas. • Allini le grandi frecce. • Allini le grandi frecce. 15 Secure with ¼” Allen wrench. • Asegure con la llave Allen del ¼”. • Fixez clé Allen avec de ¼”.
PAGE 9
17 RJ45 24VAC 1 2 3 4 Camera Camera Heater/Blower Heater/Blower POWER Red Orange Yellow Green Max 40 Watts 26 Watts 1/0 Alarm 1 Alarm 2 Alarm 3 Common 1 2 3 4 Blue Violet Gray White BNC Make the appropriate male and female connections. Indoor model does not include pre-run cables. • Haga las conexiones masculinas y femeninas apropiadas. El modelo de interior no incluye pre-funciona los cables. • Établissez les rapports masculins et femelles appropriés.
PAGE 10
English Important information for the Axis 233D model of camera. Due to the high 35x zoom feature of the Axis 233D camera, a slight focus issue may occur when the camera lens is fully extended within the Videolarm camera housing. For applications where the full 35x high-powered zoom is needed, please contact Videolarm to request a complimentary enhanced optically clear acrylic dome. Español Información importante para el modelo del fotográfica.
PAGE 11
PB24 Addendum Additional wires are provided to run power to PB24. Use with connector supplied. Run RJ45 connector through PB24, wall mount, and connect lead from housing. • Los alambres adicionales se proporcionan a la energía funcionada con a PB24. El uso con el conectador proveyó. Funcione con el conectador RJ45 con PB24, emparede el montaje, y conecte el plomo de la cubierta. • Des fils additionnels sont fournis à la puissance courue à PB24. L'utilisation avec le connecteur a fourni.
PAGE 12
Replacement Parts List 14 RHW75 IRHW75 15 16 13 12 11 10 9 8 7 5 4 6 3 1 2 1 1A 2 3 4 5 5A 6 7 8 8A 9 10 11 12 13 14 15 16 N/S N/S N/S PART NUMBER RC7C RC7T RPRH752 RPRH7503 RPNET02 RPFD072 RPFD072/12 RPFD080 RP3510 RP70FP7PB RP70FP7PB12 RPFD041 RPFD2612 RPFD3245 RPGK3356 RP3458 RP3551 RP3606 RP3719 RPPKH2098 RPPKE1100 RPTRAN02 DESCRIPTION CLEAR REPLACEMENT CAPSULE TINTED REPLACEMENT CAPSULE LOWER TRIM RING DOME CLAMPING RING NETWORK HGS POWER SUPPLY 24V HEATER 12V HEATER (12VDC MODELS ONLY) B
PAGE 14
NOTE: ! For all RHP and RHW models a ½” (13mm) spacer is added for additional height. Für alles RHP und RHW modelliert eine ½“ (13mm) Distanzscheibe hinzugefügt für zusätzliche Höhe. Deutsch English Para todo o RHP e RHW modela um espaçador do ½” (13mm) é adicionado para a altura adicional. Para todo el RHP y RHW modela un espaciador del ½” (13m m) se agrega para la altura adicional.
PAGE 15
ARECONT: AV8185 / AV8365 / AV20185 / AV20365 • Mounting holes (4-#8 x ¾”) (4) (4) (75mm) 1” (100mm) 1” 2” AVIGILON: HD-Dome Series • Mounting holes (3-#8) (3) (3) 1” 2”
PAGE 16
AXIS: 215 • Mounting holes (4-#8) (4) (4) (100mm) 1” (4) (4) (25mm) 1” 1” 2” AXIS: 233D • Mounting holes (4-#8) BASLER: BIP2-1000C-DN / BIP2-1300C-DN / BIP-D1000C-DN / BIP-D1300C-DN • Mounting holes (3-#8) (3) (3) (100mm) 1” 1” 2”
PAGE 17
CANON: VB-C60 • Mounting holes (1) (1) (1) (64mm) ½” 2” (1) (64mm) ½” 2” (1) (88mm) ½” CANON: VB-M40 • Mounting holes (1) (1) CANON: VB-C300 • Mounting holes (1) (1) 1” 2”
PAGE 18
ELMO: PTC 400C • Mounting holes (4-#8) (4) (4) (100mm) ½” (38mm) ½” 1” ½” 2” JVC: VN-V686BU / VN-V685U • Mounting holes (3-#8) (3) 1” PANASONIC: BB-HCM580/581 • Mounting holes x (1) (1) (1) (88mm) ½” 1” 2”
PAGE 19
PANASONIC: WV-CS580 Series • Mounting holes (4-#8) (38mm) ½” 1” PANASONIC: SC386 • Mounting holes (4-#8) (4) (4) (25mm) (4) (50mm) 1” PANASONIC: WV-CS574 • Mounting holes (4-#8) (4) 2”
PAGE 20
PANASONIC: WV-CS954 / WV-NS954 • Mounting holes (4-#8) (13mm) (4) ½” PANASONIC: WV-NS202 / WV-SC385 / WV-SC384 • Mounting holes (4-#8) (4) (4) (75mm) 1” (3) (25mm) 1” PIXORD: P-463 • Mounting holes (3-#8) (3) 2”
PAGE 21
SANYO: VCC-HD 5400 • Mounting holes (2-#8) (2) (64mm) 2” ½” SONY: EP / ER Series (520 / 550 / 580) • Mounting holes (4-#8) (4) (4) SONY: RX Series (RX530 / RX550 / RX570) • Mounting holes (4-M3) (4) (38mm) ½” 1”
PAGE 22
SONY: SNC RH/RS Series (RH124 / RS44 / RS46) • Mounting holes (4-#8) (25mm) (4) 1” SONY: SNC-RZ25 • Mounting holes (2-M3) (2) (1) (1) (1) (13mm) (1) (1) (1) (50mm) ½” SONY: SNC-RZ50 • Mounting holes (2-M3) (2) 2”
PAGE 23
TOSHIBA: IK-WB16A • Mounting holes (1) (1) (1) (88mm) ½” 2” 1” TOSHIBA: IK-WB21A • Mounting holes (4-#8) (4) (4) (75mm) 1” 2” (75mm) 1” 2” VIDEO IQ: VIQ-CT / CID / CRD / HD-CRD • Mounting holes (4-M4x10) (4)
PAGE 24
Product Registration/Warranty Thank you for choosing Moog Videolarm. We value your patronage and are solely committed to providing you with the highest quality products available and superior customer service. Should a problem arise, rest assure that Moog Videolarm stands behind its products by offering impressive warranty plans: 3 Years on all Housings, Poles, Power Supplies, and Accessories and 5 Years on camera systems (SView, QView, Warriors), and InfraRed Illuminators.