Operating instructions

Anchor Jig Assembly

Anchor Jig Kit Parts List

Single Straps (4)

Cross Strap (1)

3/4" - 10 Bolts (4)

3/4" Flat Washers (4)

3/4" - 10 Hex Nut (20)

Lock

Washers (4)

CAUTION: To prevent corrosion; never mix galvanized hardware

with stainless steel hardware!

Anchor Jig Assembly

1 "

6"*

Figure 1

1 1/2"

1. Thread two (2) nuts onto each of the (4) bolts (Figure 1). The end

with 6" of clearance will be the top of the Anchor Jig, the end with

1 1/2" clearance will be the bottom.

NOTE: Because of surface conditions it may be necessary to use

leveling nuts.

1 2

Anchor Jig Assembly

Figure 2

Place the short end of each Bolt into the outside holes of the

Cross Strap. PlaceHex Nuts onto each Bolt and ﬁ nger tighten.

Anchor Jig Assembly

Figure 3

Turn the Anchor Jig over and place Single Straps over the Bolts.

Use the inside hole of each strap. Place Hex Nuts

onto each

Bolt and ﬁ nger tighten.

Sold Separately

Sold Separately Sold Separately