User Manual

SEQUENCER PANEL FUNCTION QUICK REFERENCE (continued)

KB MODE PANEL FUNCTIONS (continued)

SET END STEP | KB MODE

Press (SHIFT)+SET END.

If the desired end step is

on a different page, press

(SHIFT)+Page button 1-8,

9-16, 17-24 or 25-32. To

specify the last step in

the current pattern, press

(SHIFT)+Step button 1-8.

If the new end step is after the previous end step, the notes are lled as follows: If the steps after the

previous end step have never been edited and stored in memory, or if the pattern was initialized, then

all steps get the default note value (-1V) and gate length (50%). If the steps were previously edited,

then they are restored.

STEP MODE PANEL FUNCTIONS

PATTERN PAGE SELECT | STEP MODE

Press Pattern Page button 1-8, 9-16, 17-24, or 25-32. If the

sequencer is running, selecting a page pauses the chasing

behavior of OCTAVE / LOCATION LEDs 1-4, and the Step buttons

address only steps on the selected page. To resume the LED

chasing behavior, press the currently selected Page button again.

ENABLE/DISABLE STEPS | STEP MODE

Press any Step button 1-8 to toggle

steps On/Off. The state of each step is

indicated by Step LEDs 1-8. If a step is

Off, Octave/Location LED 8 will be lit

yellow to indicate the step contains a Rest.

SET END | STEP MODE

Press SET END followed by

a Step button corresponding

to the desired last step.

If the new end step is after

the previous end step, the notes are lled as follows: If the steps after the previous end step have never

been edited and stored in memory, or if the pattern was initialized, then all steps get the default note

value (-1V) and gate length (50%). If the steps were previously edited then they are restored.

ROTATE SEQUENCE | STEP MODE

Press the RIGHT arrow to move all steps right by one step.

Press the LEFT arrow to move all the steps left by one step.

Specify Last Step In Current Pattern

Select Page Of End Step Set End Step

Select Pattern Page / Activate LED Chasing

Enable/Disable Steps

Specify Last Step In Current Pattern

Rotate The Pattern Steps