User Manual

Page 56
LP Stage II User’s Manual - The User Interface
Page 57
LP Stage II User’s Manual - The User Interface
SECTION
CONTROL/PARAMETER FUNCTION CC VALUE/RANGE
Envelope Generator
ATTACK Adjusts the lter envelope attack time 23 0 – 127
DECAY Adjusts the lter envelope decay time 24 0 – 127
SUSTAIN Sets the lter envelope sustain level 25 0 – 127
RELEASE Adjusts the lter envelope release time 26 0 – 127
ATTACK Adjusts the volume envelope attack time 28 0 – 127
DECAY Adjusts the volume envelope decay time 29 0 – 127
SUSTAIN Sets the volume envelope sustain level 30 0 – 127
RELEASE Adjusts the volume envelope release time 31 0 – 127
EGR RELEASE ON/OFF Sets the state of the EGR Release parameter 111 0 (OFF), 64 (ON)
EGR LEGATO Sets the state of the EGR Legato parameter 112 0 (ON), 43 (OFF)
86 (RESET)
Arpeggiator
ARPEGGIATOR ENABLE Enables/disables the Arpeggiator 113 0 (OFF), 64 (ON)
ARP RUN/STOP Starts and stops the Arpeggiator 90 0 (OFF), 64 (ON)
ARP CLOCK RATE
(SEE NOTE 2)
Sets the Arpeggiator Clock Rate 4 (coarse)
36 (ne)
0 – 127
ARP CLOCK SOURCE Sets the Arpeggiator Clock Source 114 0 (INT), 43 (LFO)
86 (MIDI)
ARP CLOCK DIVISIONS Sets the Arpeggiator Clock Divider 115 See table for list of values
ARP RANGE (OCTAVES) Sets the Arpeggiator Octave Range 116 0 (-3), 19 (-2)
38 (-1), 57 (0), 71 (+1)
90 (+2), 109 (+3)
ARP PATTERN Selects the Arpeggiator Pattern 117 0 (UP), 43 (DOWN)
86 (ORDER)
ARP MODE Selects the Arpeggiator Mode 118 0 (LOOP)
43 (BACK/FORTH)
86 (ONCE)
ARP LATCH ENABLE Enables/disables the Arpeggiator Latch 119 0 (OFF), 64 (ON)
ARP LATCH/UNLATCH Sets the Latch/Unlatch status 91 0 (OFF), 64 (ON)
Output
VOLUME Volume Control 7 0 – 127
Keybd
KEYBOARD NOTE
PRIORITY
Selects the Keyboard Note Priority 88
0 (GLOB), 32 (LOW)
64 (HIGH), 96 (LAST)
Left-Hand
Controller
MOD WHEEL
(SEE NOTE 1)
Modulation Performance Control
1 (MSB)
33 (LSB)
0 – 127
LP Stage II MIDI CC messages