User Manual
Page 38
LP Stage II User’s Manual - The User Interface
Page 39
LP Stage II User’s Manual - The User Interface
POT MAPPING (con’t):
Press the CURSOR button once more to select whether the assign-
ment applies to internal only (INT), external only (EXT) or BOTH.
Pressing the CURSOR button again will return you back to the
beginning.
Once programmed, Pot Mapping is enabled in a section by selecting
the active parameter in that section. For example, suppose Pot
Mapping is congured for the MODULATION knob to send MIDI
CC#10. To activate Pot Mapping in the Modulation section, press the
button that is currently active (i.e. lit) in that section. The button will
turn off (no button in the Modulation group will be illuminated); the
MODULATION knob will now send MIDI CC#10 information when
it is adjusted. To disable Pot Mapping in the Modulation section, simply
press one of the buttons in that section, and the MODULATION
knob will return to its normal function.
Values: MIDI CC assignments: OFF, 0-127
Destination: INT, EXT, BOTH
PERFORMANCE TIP: Here’s a Pot Mapping example: suppose you have an external audio device
that you want to control independently of the LP. You could program Pot Mapping to have the
Modulation control transmit MIDI CC #XX, but only have it programmed for external control (EXT).
With this setup, you press the active control in the Mod section (either the LFO Rate or Amount
switch) to engage Pot Mapping without affecting your LP’s sound or state. Now when you adjust the
MOD control, it sends MIDI CC #XX out to your external MIDI device, but has no effect on the LP’s
sound engine.