Instructions)

10) Slowly place the panel onto the front of the cabinet so the potentiometer leads stick through the
appropriate pads on the 11-213 PCB (shown in gure 7).
11) Holding the panel in place, ip the unit over and install the three screws that fasten the panel to the bottom of
the cabinet.
12) Reinstall the mic stand adapter.
13) Turn the unit over. Solder the pot leads to the PCB.
14) Make the following connections (nal result shown in gure 8):
5-wire harness connector to 11-213 PCB connector labeled J2
10-wire connector to 11-211 PCB connector labeled CN1
#6 locking terminal to Foil strip (screw terminal down)
Phones Out to 11-213 PCB connector labeled J7
Audio Out to 11-213 PCB connector labeled J8
Grey/white wires to Power switch terminals
gure 7
gure 8
15) Turn the pots all the way down (full CCW). Install the knobs so the indicators point to 7:00.