Instructions)

ETHERWAVE PLUS:

TEMPLA

TE FOR MARKING LOCATION OF HOLES

This template is used for marking the locations on the bottom of the cabinet for the three holes that must be drilled to mount the

11-213 PCB assembly.

Instructions:

1) Cut out the rectangle below. Be sure to use a straightedge and cut the bottom edge accurately.

2) Prepare three small pieces of scotch or masking tape to fix the template in place.

3) Line the bottom edge of the template up with the front panel edge of the cabinet.

4) Line the center small hole up with the center hole for the front panel.

5) Tape the template in place without allowing it to move.

6) Using your center punch, mark the center of the three large holes into the bottom of the Etherwave Cabinet,

7) Remove the template and proceed with drilling the holes as described in the manual.

These three holes should line up with the holes drilled for the front panel

This edge should

be lined up with

the front edge

of the cabinet

on the bottom of

the cabinet.