Manualshelf

User Guide

ManualsBrandsMoog Music Inc. ManualsElectronic KeyboardsMoog Grandmother Semi-Modular Analog Keyboard Synthesizer
31323334353637383940
40
PATCH POINT INDEX FRONT PANEL (Continued)
OSCILLATORS MODULE (Continued)
OSCILLATOR 2 PITCH IN: The control signal received here is summed with the internal
Pitch CV to modulate the pitch of Oscillator 2.
90K Ohms; -5 to +5 Volts.
OSCILLATOR 2 LIN FM IN: The control signal received here is summed with the internal Pitch
CV to introduce linear FM (Frequency Modulation) to Oscillator 2.
90K Ohms; -5 to +5 Volts.
MIXER MODULE
OSC 1 IN: The audio source or control signal connected to this input will replace the normalled
connection of the output of Oscillator 1 to the input of the mixer. The mixer’s OSCILLATOR 1
knob will now control the level of this new signal.
100K Ohms; -5 to +5 Volts.
OSC 2 IN: The audio source or control signal connected to this input will replace the normalled
connection of the output of Oscillator 2 to the input of the mixer. The mixer’s OSCILLATOR 2
knob will now control the level of this new signal.
100K Ohms; -5 to +5 Volts.
NOISE IN: The audio source or control signal connected to this input will replace the normalled
connection of the output of the Noise generator to the input of the mixer. The mixer’s NOISE
knob will now control the level of this new signal.
100K Ohms; -5 to +5 Volts.
OUTPUT (MIXER OUTPUT): The combined output of all mixer input sources is available via this
output jack.
2K Ohms; output level is determined by the combined individual level knob settings.
UTILITIES MODULE
MULT JACKS: The four unbuffered MULT jacks can be employed either as inputs or outputs,
and can accommodate audio signals or control signals. Any signal (audio or control) can be
inserted into one MULT jack and distributed to up to three locations by using the remaining
jacks as outs. In special cases, the MULT jacks can be used to merge up to two audio AC
coupled audio sources (OSCILLATOR 1 WAVE OUT, OSCILLATOR 2 WAVE OUT, FILTER OUT,
HP FILTER OUT, WET OUT, and the EURORACK OUT) and to send the merged signal to up to
two destinations using the remaining two jacks.
HIGH PASS FILTER INPUT: The audio source connected to this input will be processed by the
High Pass Filter.
110K Ohms; -5 to +5 Volts.
HIGH PASS FILTER OUTPUT: The output of the High Pass Filter is available via this jack.
2K Ohms; 10 Volts Peak-to-Peak (AC Coupled).
ATTENUATOR INPUT: This jack provides an input to the Inverting Attenuator.
100K Ohms; -8 to +8 Volts.