User Guide

39
PATCH POINT INDEX FRONT PANEL
ARP / SEQ MODULE
GATE OUT: This jack produces a Gate with each new note played on the keyboard, played by
the Arpeggiator, or played by the Sequencer.
5 Ohms; +8 Volt Gate.
KB OUT: This jack delivers a Control Voltage (CV) based on the key played by the Keyboard,
Arpeggiator, or Sequencer.
5 Ohms; -5 to +5 Volts.
KB VEL OUT: This jack delivers a Control Voltage (CV) based on the velocity of the key played
by the Keyboard or Arpeggiator. During Sequencer playback, this jack will output a
control voltage envelope when steps with an Accent are played.
5 Ohms; 0 to +5 Volts.
MODULATION MODULE
RATE IN: The control signal received here is added to the value of the RATE knob to determine
the speed of the Modulation Oscillator.
100K Ohms; -5 to +5 Volts.
SYNC IN: The rising edge of a control signal received will reset the Modulation Oscillator to its
starting point.
100K Ohms; 0 to +5 Volts.
WAVE OUT: This jack outputs the selected Waveform as a control signal, at the current
Rate setting.
5 Ohms; 10 Volts Peak-to-Peak (DC Coupled).
S/H OUT: This jack delivers a random Control Voltage (CV) created by sampling the value of
the Noise source at each zero-crossing of the Modulation Oscillator.
2K Ohms; -5 to +5 Volts.
OSCILLATORS MODULE
OSCILLATOR 1 WAVE OUT: This jack outputs the selected Waveform as a control signal, at the
current Frequency.
2K Ohms; 10 Volts Peak-to-Peak (AC Coupled).
OSCILLATOR 1 PITCH IN: The control signal received here is summed with the internal Pitch
CV to modulate the pitch of the Oscillator 1.
90K Ohms; -5 to +5 Volts.
OSCILLATOR 1 PWM IN: The control signal received here can modulate the duty cycle, or
pulse width, of the Square wave (50% starting duty cycle) or the Narrow Pulse wave
(25% starting duty cycle).
100K Ohms; 0 to +5 Volts.
OSCILLATOR 2 WAVE OUT: This jack outputs the selected Waveform as a control signal, at the
current Frequency.
2K Ohms; 10 Volts Peak-to-Peak (AC Coupled).