User Guide

32
CREATE A SEQUENCE (Continued)
ADD A REST
Press the REST button.
NOTE: During playback, this step will be silent.
ADD AN ACCENT
Finally, play one last note and then
press the ACCENT button.
NOTE: During playback, this step will
output an Accent voltage from the
KB VEL OUT jack that can be patched
into other modules. A good place
to try would be into the CUTOFF
IN jack in the Filter section.
END RECORDING
To end recording, set the MODE switch to the SEQ position.
PLAY YOUR SEQUENCE
Now press the PLAY button and
then press a note to listen to your
sequence.
NOTE: You may transpose your
sequence by playing a new note.
TIP: Use the RATE knob to adjust the
playback speed.
DO YOU LIKE YOUR SEQUENCE?
NO!
To delete your sequence, simply start over at the beginning of this tutorial.
YES!
To keep your sequence and create another one, follow the above directions, but be sure to set
the OCT / SEQ switch to 2 or 3. (There are three available sequence locations.)
+