User Manual

Table Of Contents

Setup and Operation

3. Ensure the power switch is set to the OFF position and the STANDBY

SWITCH is set to the STANDBY position. Connect your TUBE ENGINE

to your AC mains supply using a 3 pronged AC power chord.

4. Put the power switch in the ON position and wait for at

least 30 seconds for the tubes to warm up. This will help to

extend tube life. Standby can also be used to keep the

tubes warm when taking a break.

5.Put the STANDBY SWITCH in the ON position to operate the

ampliﬁer. Adjust the HI/LOW SWITCH, VOLUME and PRESENCE

controls to your liking.

30 seconds