User Manual

Pedal Layout
2
1
3
4
5
1
6
10
8
7
9
VOL: Volume pedal only. In this mode freestep will behave like
any ordinary volume pedal. Heel down is minimum volume and
toe down is maximum volume. Minimum volume can be
adjusted between 0%-50% using the MIN VOL dial on the side
of the pedal
5. Pressure SENSOR pads:
Used for activating the wah in sensor setting
6. Touch Switch:
Footswitch for traditional toe down Wah activation
7. MODE switch:
Change between the three modes.
Wah/Volume/Wah&Volume
8. SENSOR/SWITCH:
Change the activation method when in Wah mode.
9. Q Range dial:
Adjusts the value of Q range to dial in the sound
of your wah
10.MIN VOL dial:
Adjusts the minimum volume between 0%-50%
of the heel down position when in volume and
wah&volume mode.
1. Power LED:
Indicates the On/Off status and mode of Freestep.
(Red for Wah, Blue for Volume)
2. INPUT:
¼ inch audio input Jack
3. OUTPUT:
¼ inch audio output Jack
4. DC input:
Connect a 9v DC power supply centre pin negative
Connections
Connect your instrument to the freestep input using a
standard 1/4" guitar jack cable.
Connect the output of freestep to the input of your
amplifier, effects pedals or other equipment using a
standard 1/4" guitar jack cable or connector
Connect a 9v DC power supply to the DC input. Ensure
the polarity is centre pin negative
Get your foot on freestep, crank up the volume and have
fun!!!
MOOER AUDIO CO.,LTD
www.mooeraudio.com
MODES
Freestep has 3 different modes which can be changed using
the "MODE switch" on the side of the pedal.
Wah: Wah effect only. You can operate the wah with two
different methods in this mode which can be changed using
the "SENSOR/SWITCH" control.
With this control in SENSOR position, simply place the
sole of your foot onto the pedals pressure sensor pads to
activate the effect.
Remove your foot to deactivate the effect.
With this control in the SWITCH position, lean forward
and apply slight pressure to the front of the pedal with your
foot while the pedal is in the full toe down position to push
the Touch Switch and activate the effect. The effect will
remain active until you use the same method to deactivate it.
Use the Q range dial to adjust the sound of the wah
effect
Part No:620010593
W&V: Wah and Volume mode. In this mode freestep will act as
a volume pedal by default. To activate and deactivate the wah
effect, use the second method described above in 'wah mode'.
The SENSOR/SWITCH control is inactive in this mode.
When in Volume mode the LED's will illuminate blue.
When actively in wah mode the LED's will illuminate red.
(Heel down) (Toe down)