User Manual

Specifications
*Notes: Any specification’s update will not be amended in
this manual.
Modes and Switching
Part No:620010618
1. LED：
Indicates the on/off status of the effect pedal
2. Input jack :
1/4” audio jack for connecting to the input
device or instrument.
3. Output jack :
1/4” audio jack, effect output for connection
to amp or other devices
4. DC in power jack:
Input for power supply, use a 9V DC regulated
power supply , center pin negative.
5. Pedal extension rings:
Can be extended to increase pedestal surface
area and increase comfort
6. Pressure sensing pads：
Activates the effect by detecting the presence
of your foot.Front sensing pad is used to change
Effect mode. Rear sensing pad is used to change
switching mode.
7. Expression Pedal:
Controls vocal sweep of the effect
Press and hold the toe pressure sensing pad while the
pedal is connected to power
Disconnect the power whilst continuing to hold the
Reconnect power
TALK MODES
The RED KID has two different TALK modes, each with a
different vocal sound.To change TALK mode:
The LED's will flash BLUE to confirm the mode has
changed. Flashing once means mode
1, flashing twice means mode
2. Release the pressure sensing pad to resume operation
RED KID has 3 different types of switching.
1.Touch the pressure sensing pads with your foot to turn on
the effect. Release your foot from the pedal to turn off the
effect
2.Double tap the pressure sensing pads to turn on the effect.
The effect will remain on untill you double tap the
pressure sensing pads for a second time
3.In this switching mode you can use both techniques
mentioned above for switching the effect on and off
SWITCHING MODES
Press and hold the heel pressure sensing pad while the
pedal is connected to power
Disconnect the power whilst continuing to hold the
sensing pad
Reconnect power
To change switching mode:
The LED's will flash RED to confirm the mode has changed.
Flashing once means mode
1, flashing twice means mode
2, flashing three times means mode
3. Release the pressure sensing pad to resume operation.
Input：1/4” mono audio jack.（Impedance: 1M Ohms）
Output：1/4” mono audio jack（Impedance: 100 Ohms）
Power requirements: AC adapter 9V DC , center
negative. Highly recommend to use Mooer Micro Power.
Cur rent Dr aw：130mA
Dimensions：128mm(D) x 55mm(W) x 48mm(H)
Weight：460g
Accessories：Owner’s Manual
2
1
3
4
5
6
1
7
Pedal layout