precaution * PLEASE REAR CAREFULLY BEFORE PROCEEDING * Power Supply Please connect the designated power cable to an AC outlet of the correct voltage. Unplug the power cable wham not using or during electrical storms. Connections Always disconnect the power of the L6 unit and all other equipment before connecting or disconnecting, this will help prevent malfunction and / or damage to other devices. Also make sure to disconnect all connection cables and the power cord before moving this uri.
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth. Do not use abrasive cleanser, cleaning wholemeal, paint thinners, wax, solvents, cleaning fluids, or chemical-impregnated wiping cloths. Handling Do not apply excessive force to the switches or controls. Do not allow paper, metal, or any other foreign objects to enter Inside of this unit. Take Cara not to drop the unit, and do not subject it to shock or excessive pressure.
1. INPUT Jack: % Audio jack Input for connecting Instrument. 2. Tuner Jack: %" Audio output jack to connect Tuner. 3. DC IN Jacks Input jack for the L's power supply. 4. Loop Jack Input and output audio jacks for connecting effects pedals. 5. Output Jacks" audio output jack for connecting the LE ta an amplifier or other audio equipment. 6. MUTE FOOT SWITCH:Dadlcated foot switch for muting the backpedal. 7. PUB-F : Activation button far the per-positian buffer. BUD-F Is situated In Front of the first loop.
Thea are 2 modes of operation available on the L8. LIVE midi PLAY mode. PLAY med: PLAY mode Is the default operation mode on the LE. In this mode the user can save and recall up to 38 preset configurations, allowing simultaneous angagement/disengagement of multiple lops with the press of one foot switch. The LE has & banks with six presets In each bank. Na ans: Simultaneously press foot switch number 1 and 2to change the hank down. Simultaneously press foot switch 3 and 4 to ‘change the bank up.
In LIVE mode the operation of the L6 is more leeks that of a traditional pedal board. Each numbered foot switch controls the engagement and disengagement of I's corresponding loop number (l.e. Bewitching 1 controls loop number 1 . Foot switch 2 controls loop number 2. Etc.) When a loop Is snagged the commandeering backbit loop display panel will illuminate brightly. When the loop Is disengaged the backbit loop display panel will becomes dark. To activate LIVE mode simply press the LIVE/BACK button.
angel Instructions INITIAL STARTUP When the L6 is first powered up it's default mode is PLAY mode and the LED display will read P-1-1 (Play mode-bank-preset1). To activate Live mode simply press the LIVE/BACK button once. To return to PLAY mode simply pass the LIVE/BACK button once. EDITING/SAVING/RESET EDIT: To edit a press while In PLAY mods simply navigate to the bank and press you wish to edit. Then press the EDIT/SAVE button once.
If you wish to cancel saving and return to EDIT mode press the LIVE/BACK button once. To exit out of EDIT mods and resume normal operation of the L6 press the LIVE/BACK button incs. FACTORY RESET: Whilst in PLAY mode simultaneously press and hold the EDIT/SAVE button and the LIVE/BACK button for aver 5 seconds. This will reset all of the saved presets to the factory default settings. WARNING This will eras all saved presets. The L8 has two available signal BUFFERS.
Specification Input: 1/4” monaural Jack (Impedance: 2M Ohms) 1/4" monaural jack (impedance: 100 Ohms} mints: AC adapter 9V DC (center minus plug), supply Is recommended nt Draws: 350 mA Dimensions: 370mm (D) x 87mm (W) x 33mm (H) Wrought: 1.
